Rnode firmware for Nullhop Meshtoad V3?
Started by nyla 326949caa2f584e4... ·
Hello, I was wondering if Rnode firmware exists for the Nullhop Meshtoad V3, so that can be used with reticulum instead of just meshtastic and meshcore, or if there is a way to use it with reticulum as I'm not sure if Rnode firmware would be required to do so.
Disclaimer: I am new to this. But yes you need Rnode firmware. And unless the board is nRF52840 or ESP32 based there is currently no support. I could not find good info with a glance but I think the board is based on something else. Someone correct me if I'm wrong.
nyla wrote:
Hello, I was wondering if Rnode firmware exists for the Nullhop Meshtoad V3, so that can be used with reticulum instead of just meshtastic and meshcore, or if there is a way to use it with reticulum as I'm not sure if Rnode firmware would be required to do so.
If you're willing to test it out, it should be pretty trivial to add RNode support to it. I don't have the device but I can help out with making it support Rnode. Feel free to message me at bafe8eceade55551fa1a17a6c0dcfd77